The paper pipette machine is also a very widely used paper tube mechanical equipment. This paper mainly analyzes some faults that often occur in the use of the pipe suction machine. It explains the causes of the failure and the elimination methods to help you to be more able to follow up. Reasonable use of this device for pipettes.
    1. The spiral inside the paper pipe drawing machine produced is very uneven
    The occurrence of such a situation is mainly caused by the following major aspects. For example, during the operation of the cutting blade inside the straw machine, the resistance to the paper tube is too large. At this time, we only need to correspondingly the blade. Adjust and adjust the resistance appropriately.
    Of course, it may also be because the first layer of paper tape is applied with less lubricant, or the application of the lubricant is very uneven, and we need to re-lubricate the first layer of paper tape. The application ensures that the application is uniform, so in general, when we apply the lubricant to the tape for the first time, we should make a proper selection of the amount of lubricant and apply it evenly, so that the subsequent products The production process will be relatively convenient.
   2. The unevenness of the surface of the paper tube produced
   This situation is mostly caused by the asymmetry of the winding angle of the two belts inside the straw machine equipment, which leads to the situation that the belt unidirectionally presses the paper tube during the operation of the equipment, resulting in the subsequent production of the paper. The surface of the straw is very uneven, we only need to adjust the internal belt winding angle by handwheel.
    3. The uneven distribution of the binder on the paper tube
   If the internal scraper does not form a right angle with the paper strip or if there are some magazines on the scraper, it will actually cause uneven adhesion of the adhesive on the paper tube. Therefore, after the operation of our team equipment, we need to clean the interior, remove the magazines including the scraper and some other parts, let the equipment enter the corresponding operation, and then, during the operation, if some When the adhesive is unevenly applied, we can properly adjust the angle between the blade and the tape, and the angle of the blade edge to keep it at a right angle, so that the device can effectively make a stable paper pipe production. .
   4. Cutting the paper tube for too long or too short
   Generally, in the process of producing a paper straw, the time for cutting the paper tube is kept at a fixed value, so that the cutting time is too long or too short, indicating that the device may have some problems, this At the time we need to adjust the equipment accordingly, adjust the cut-off time to keep it in the paper tube for one week.

On a message：Why are paper pipettes so hot now?      Next information：Not available